The function of the injection pump test bench is to test and adjust the fuel injection quantity of the fuel injection pump at the calibrated rotation speed, corrected rotation speed, idle speed, and starting rotation speed.
Specifically, the calibration, calibration speed is 400 injections, idle speed, and start-up is 100 injections. Therefore, it is necessary to provide the injection pump with the power of rotation of the camshaft, provide calibration pump oil, provide the number of injections and measure the amount of oil. Therefore, after the fuel injection pump is clamped on the test bench, its main shaft and the camshaft of the fuel injection pump are linked together.
After the test bench is started, after the oil supply system is started, the test bench supplies the pump oil to the injection pump, and the spindle speed is adjusted by The speed of the camshaft of the fuel injection pump reaches the specified speed respectively. The operator fixes the fuel pump speed control handle to the specified position, such as the full load, idle position, etc., and detects the extension length of the fuel adjustment lever. After the adjustment, the fuel amount is turned on. The metering device is an oil cup, which detects the amount of fuel injected and the difference between cylinders, and then adjusts each cylinder individually. Meet the specification that is adjusted.
Proper maintenance of diesel fuel injection pump
1. When the fuel injection pump is installed on the diesel engine, the fuel supply advance angle must be checked. After 500 hours’ operation, the fuel supply advance angle shall be checked again.
We must use the national standard light diesel oil, and the diesel oil should have 48~96 hours’ sedimentation and filtration.
Pay attention to the cleaning of diesel tank and filter
Checking the engine oil every day, filling it when it is insufficient.
There is a skeleton oil seal between the fuel injection pump and the governor, so it needs to fill oil separately.
If the oil level increases due to oil dilution, indicating that the injection pump or oil pump seriously leakage. The problem should be promptly removed.
100 hours after the diesel engine running, the oil and clean the oil pump strainer should be replaced.
Fuel injection pump shall not be free to disassemble and adjust, especially the parts with sealing. The work site must be cleaned if it is necessary to disassemble and repair.
After 2000 hours working, the injection pump should be completely removed, check; replace or repair worn and damaged parts, and re-commissioning.
Depending on the advanced maintenance technology, Taixi International Trading has not only distributed Taixi Auto Maintenance products to hundreds of auto 4S shops in China, but also exported to U.S.A., Germany, Russia, India, Korea, Thailand, South Africa, Israel, Oman, Ukraine, and Belarus and so on.
Any questions, please leave your information or contact us directly. We will reply within 24 hours.
济南泰西国际贸易有限公司 No. 8, Daluzhuang Industrial Park, Jinan City, 185 6372 7557 185 6372 7557 manager@cntestbench.com
